Limestone adds a soft, natural look to any design with a palette of neutral and organic tones including light beiges, dark beiges, browns, taupes, grays and whites
Roll over image to zoom
-
Additional Colors
:
L343
:
3/8
:
12X24
:
Lite Honed
:
L: Low
:
Morocco
:
L343
:
5/8
:
12X24
:
Tumbled
:
L: Low
:
Morocco
:
L343
:
3/8
:
2
:
Mix
:
H: High
:
China
-
Usage Chart
Grout Joint Recommendation 1/16" to 1/8", 1/8", 1/8" to 3/8" Durability 2 Medium/Light Commercial: Suitable for light commercial and residential use. Soundness Group C: These stones may contain holes, voids, lines of separation and structural flaws. It is standard practice to repair these stones by filling them or reinforcing them. Exterior Usage NA Not recommended for exterior applications. Country of Manufacturer China Country of Origin Morocco Polished surfaces are not recommended for floor areas where slip resistance is a concern. Our durability recommendations are only based on the technical characteristics of the stones, however, slip resistance shall still be taken into consideration when selecting the product for a specific application. Natural stone products do not meet minimum coefficient of friction thresholds recommended by safety standard setting organizations. Soundness is meant to help classify denser stones (Group A and B) from more fragile stones (Group C and D). Stones classified under Groups C and D may require additional fabrication before, during or after installation as part of regular maintenance. *Covered implies an area protected from the elements. Natural stone products are not recommended for any wet areas where they may be exposed to chemicals, such as waterlines and pools, or to extreme humidity and heat, such as steam rooms, among others. A sealer is recommended. (Note: Some stones, such as limestone and tumbled stone among others, should be sealed prior to grouting.)|Install with a non-staining epoxy. Do not use any water based setting materials with these stones.|Might contain dry seams, pits, fossils and glass veins that are filled at the factory or during installation. These are all inherent characteristics of the stone. Since these voids can sometimes lose their fillings, they should be refilled as part of normal maintenance.|Not recommended for shower floors.|Not recommended in wet areas.|These stones contain deposits of minerals and iron that may react to moisture. Stone bleeding or rusting is a common example of this. These stones should not be used in installations where they would be exposed to standing, run off water or too much humidity. A sealer is strongly recommended but will not prevent the chemical reaction from happening|Use a temporary water soluble grout release during installation|White setting materials are recommended.
You May Also Like
